Detail publikačního výsledku

The Behavior of the MR Fluid During Durability Test

ROUPEC, J.; MAZŮREK, I.; STRECKER, Z.; KLAPKA, M.

Originální název

The Behavior of the MR Fluid During Durability Test

Anglický název

The Behavior of the MR Fluid During Durability Test

Druh

Článek recenzovaný mimo WoS a Scopus

Originální abstrakt

The article describes results of durability test of a magnetorheological fluid (MRF), which was carried out in rheometer of own design. The rheometer design enables to measure the rheological properties of MR fluid and to expose it to a long-term loading simultaneously, without any manipulation of the measured sample. During the durability test a change of the two most important parameters of Bingham model describing the behavior of MR fluids can be followed – dynamic viscosity and yield stress. In this paper the yield stress and viscosity were evaluated depending on temperature in OFF-state. The results show a significant change of yield strength during durability test depending on temperature of loading. Dependence of yield stress on temperature was proved. The viscosity decreased by 36% from its initial value after the dissipation of 9-20kJ.cm-3 from total 1.2 MJ.cm-3 and then has remained the same until the end of durability test. Viscosity was evaluated depending on temperature.

Anglický abstrakt

The article describes results of durability test of a magnetorheological fluid (MRF), which was carried out in rheometer of own design. The rheometer design enables to measure the rheological properties of MR fluid and to expose it to a long-term loading simultaneously, without any manipulation of the measured sample. During the durability test a change of the two most important parameters of Bingham model describing the behavior of MR fluids can be followed – dynamic viscosity and yield stress. In this paper the yield stress and viscosity were evaluated depending on temperature in OFF-state. The results show a significant change of yield strength during durability test depending on temperature of loading. Dependence of yield stress on temperature was proved. The viscosity decreased by 36% from its initial value after the dissipation of 9-20kJ.cm-3 from total 1.2 MJ.cm-3 and then has remained the same until the end of durability test. Viscosity was evaluated depending on temperature.

Klíčová slova

MR fluid, MR damper, magnetorheological, Bingham model, viscosity, yield stress, durability test, high shear rates

Klíčová slova v angličtině

MR fluid, MR damper, magnetorheological, Bingham model, viscosity, yield stress, durability test, high shear rates

Autoři

ROUPEC, J.; MAZŮREK, I.; STRECKER, Z.; KLAPKA, M.

Rok RIV

2013

Vydáno

27.08.2012

Nakladatel

IOP Publishing

ISSN

1742-6588

Periodikum

Journal of Physics: Conference Series

Svazek

412

Číslo

1

Stát

Spojené království Velké Británie a Severního Irska

Strany od

1

Strany do

8

Strany počet

8

URL

http://iopscience.iop.org/article/10.1088/1742-6596/412/1/012024

BibTex

@article{BUT93430,
  author="Jakub {Roupec} and Ivan {Mazůrek} and Zbyněk {Strecker} and Milan {Klapka}",
  title="The Behavior of the MR Fluid During Durability Test",
  journal="Journal of Physics: Conference Series",
  year="2012",
  volume="412",
  number="1",
  pages="1--8",
  doi="10.1088/1742-6596/412/1/012024",
  issn="1742-6588",
  url="http://iopscience.iop.org/article/10.1088/1742-6596/412/1/012024"
}

Dokumenty

Roupec_2013_J._Phys.__Conf._Ser._412_012024