Detail publikačního výsledku

End Mills with PCD Inserts Sharpened by Different Electrical Technologies

TRČKA, T.; POLZER, A.; SEDLÁK, J.

Originální název

End Mills with PCD Inserts Sharpened by Different Electrical Technologies

Anglický název

End Mills with PCD Inserts Sharpened by Different Electrical Technologies

Druh

Článek WoS

Originální abstrakt

Initially a natural diamond was used for cutting, but it was successively replaced by an man-made - synthetic diamond. Its application is limited only on non-ferrous materials, but also considering this limitation it is a very important cutting material. The most suited material based on diamond for milling operations is PCD - a synthetic polycrystalline diamond produced by HPHT (high-pressure high-temperature) process, because the high fracture toughness of the tool is required [DAVIS 1995] [Tso 2002]. Four end mills with PCD inserts sharpened by different electrical technologies were produced for the experiment as stated in this article. Two milling tools were sharpened by WEDM and the remaining two by Electrical Discharge Machining – Grinding. The aim of the experiment was to compare these technologies of sharpening. This was based on the surface roughness and topography analysis of sharpened surfaces of inserts, and in particular, on the force loading of the tools measured by the piezoelectric dynamometer 9257B over selected milling time slots.

Anglický abstrakt

Initially a natural diamond was used for cutting, but it was successively replaced by an man-made - synthetic diamond. Its application is limited only on non-ferrous materials, but also considering this limitation it is a very important cutting material. The most suited material based on diamond for milling operations is PCD - a synthetic polycrystalline diamond produced by HPHT (high-pressure high-temperature) process, because the high fracture toughness of the tool is required [DAVIS 1995] [Tso 2002]. Four end mills with PCD inserts sharpened by different electrical technologies were produced for the experiment as stated in this article. Two milling tools were sharpened by WEDM and the remaining two by Electrical Discharge Machining – Grinding. The aim of the experiment was to compare these technologies of sharpening. This was based on the surface roughness and topography analysis of sharpened surfaces of inserts, and in particular, on the force loading of the tools measured by the piezoelectric dynamometer 9257B over selected milling time slots.

Klíčová slova

PCD, force loading, analysis of sharpened inserts, WEDM, EDM-G

Klíčová slova v angličtině

PCD, force loading, analysis of sharpened inserts, WEDM, EDM-G

Autoři

TRČKA, T.; POLZER, A.; SEDLÁK, J.

Rok RIV

2019

Vydáno

07.03.2018

Nakladatel

MM Science Journal

Místo

Praha

ISSN

1805-0476

Periodikum

MM Science Journal

Číslo

1

Stát

Česká republika

Strany od

2192

Strany do

2197

Strany počet

6

URL

http://www.mmscience.eu/content/file/archives/MM_Science_201759.pdf

BibTex

@article{BUT146861,
  author="Tomáš {Trčka} and Aleš {Polzer} and Josef {Sedlák}",
  title="End Mills with PCD Inserts Sharpened by Different Electrical Technologies",
  journal="MM Science Journal",
  year="2018",
  number="1",
  pages="2192--2197",
  doi="10.17973/MMSJ.2018\{_}03\{_}201759",
  issn="1803-1269",
  url="http://www.mmscience.eu/content/file/archives/MM_Science_201759.pdf"
}

Dokumenty

MM_Science_201759