Detail publikačního výsledku

Influence of microstructure on machinability of material and its final surface quality

PAVLOUŠKOVÁ, Z.; HORYNOVÁ, M.; KLAKURKOVÁ, L.; JULIŠ, M.; GEJDOŠ, P.; REMEŠOVÁ, M.

Originální název

Influence of microstructure on machinability of material and its final surface quality

Anglický název

Influence of microstructure on machinability of material and its final surface quality

Druh

Stať ve sborníku v databázi WoS či Scopus

Originální abstrakt

Mechanical properties, such as hardness, yield strength and tensile strength, are very often considered as the only key factor while selecting technological parameters of materials machining. Analysis of the microstructure and specific microstructural parameters is not performed until serious problems occur during otherwise common machining processes. This study reports few case studies, dealing with such problematics, which resulted from underestimation of the knowledge of macrostructure and microstructure of material. It deals with problems such as uncommon surface defects after machining or impossibility to use current technological machining processes when machining new batch of material.

Anglický abstrakt

Mechanical properties, such as hardness, yield strength and tensile strength, are very often considered as the only key factor while selecting technological parameters of materials machining. Analysis of the microstructure and specific microstructural parameters is not performed until serious problems occur during otherwise common machining processes. This study reports few case studies, dealing with such problematics, which resulted from underestimation of the knowledge of macrostructure and microstructure of material. It deals with problems such as uncommon surface defects after machining or impossibility to use current technological machining processes when machining new batch of material.

Klíčová slova

microstructure; surface quality; machining parameters

Klíčová slova v angličtině

microstructure; surface quality; machining parameters

Autoři

PAVLOUŠKOVÁ, Z.; HORYNOVÁ, M.; KLAKURKOVÁ, L.; JULIŠ, M.; GEJDOŠ, P.; REMEŠOVÁ, M.

Rok RIV

2018

Vydáno

27.11.2017

Nakladatel

Trans Tech Publications

Místo

Switzerland

ISBN

978-80-01-06150-3

Kniha

Přínos metalografie pro řešení výrobních problémů

Edice

14

ISSN

1662-9779

Periodikum

Solid State Phenomena

Svazek

270

Stát

Švýcarská konfederace

Strany od

112

Strany do

117

Strany počet

6

BibTex

@inproceedings{BUT138787,
  author="Zina {Pavloušková} and Miroslava {Horynová} and Lenka {Klakurková} and Martin {Juliš} and Pavel {Gejdoš} and Michaela {Remešová}",
  title="Influence of microstructure on machinability of material and its final surface quality",
  booktitle="Přínos metalografie pro řešení výrobních problémů",
  year="2017",
  series="14",
  journal="Solid State Phenomena",
  volume="270",
  pages="112--117",
  publisher="Trans Tech Publications",
  address="Switzerland",
  doi="10.4028/www.scientific.net/SSP.270.112",
  isbn="978-80-01-06150-3",
  issn="1012-0394"
}