Detail publikačního výsledku

Model of Temperature Distribution of Thick Film Heating Element

BÍLEK, J., SZENDIUCH, I.

Originální název

Model of Temperature Distribution of Thick Film Heating Element

Anglický název

Model of Temperature Distribution of Thick Film Heating Element

Druh

Stať ve sborníku v databázi WoS či Scopus

Originální abstrakt

This paper is focused on the modelling of temperature distribution in ANSYS. An objective is to obtain a temperature distribution of a heater, which can be used for a transcutaneous blood gas sensor. The best temperature for measurements in this application should be in the range from 43,5°C to 44,5°C [1]. Therefore, a maximum and minimum temperature of the sensing area should be found in this range to ensure the best conditions during measurements. If the temperature distribution of the heater is described and then confirmed by an experiment, new heater design can be created without a need of new experiments and measurements. It results in a low cost and high-speed solution of the design process.

Anglický abstrakt

This paper is focused on the modelling of temperature distribution in ANSYS. An objective is to obtain a temperature distribution of a heater, which can be used for a transcutaneous blood gas sensor. The best temperature for measurements in this application should be in the range from 43,5°C to 44,5°C [1]. Therefore, a maximum and minimum temperature of the sensing area should be found in this range to ensure the best conditions during measurements. If the temperature distribution of the heater is described and then confirmed by an experiment, new heater design can be created without a need of new experiments and measurements. It results in a low cost and high-speed solution of the design process.

Klíčová slova v angličtině

ANSYS modeling, temperature distribution, thick film heating element

Autoři

BÍLEK, J., SZENDIUCH, I.

Vydáno

20.11.2001

Nakladatel

Ing. Zdeněk Novotný, CSc., Brno

Místo

Brno, Czech Republic

ISBN

80-214-1960-1

Kniha

Electronic Devices and Systems 2001

Strany od

248

Strany počet

5

BibTex

@inproceedings{BUT6562,
  author="Jaromír {Bílek} and Ivan {Szendiuch}",
  title="Model of Temperature Distribution of Thick Film Heating Element",
  booktitle="Electronic Devices and Systems 2001",
  year="2001",
  pages="5",
  publisher="Ing. Zdeněk Novotný, CSc., Brno",
  address="Brno, Czech Republic",
  isbn="80-214-1960-1"
}