Detail publikačního výsledku

The Use of Microstructural Analysis for the Evaluation of Quality of Double-Wall Pipes

KLAKURKOVÁ, L.; JULIŠ, M.; GEJDOŠ, P.; HORYNOVÁ, M.

Originální název

The Use of Microstructural Analysis for the Evaluation of Quality of Double-Wall Pipes

Anglický název

The Use of Microstructural Analysis for the Evaluation of Quality of Double-Wall Pipes

Druh

Stať ve sborníku v databázi WoS či Scopus

Originální abstrakt

This contribution is based on case studies concerning failure of double-wall pipes due to several factors. Series of double wall-pipes from different suppliers were studied using light and electron microscopy in order to reveal defects which led to the failure of each set of the pipes. Pipes, made of combination of steel and copper were analysed in the initial state and after heat treatment. Heat treatment, was performed by the suppliers, not further specified, and varied between suppliers [1, 2]. Metallographic analysis revealed unsuitable microstructure of steel layers and heterogeneity in Cu layer. More detailed analysis revealed precipitation of Cu-based phase on the Cu-steel interface resulting from heat treatment process, but for one set of tubes, precipitates were observed even in the initial state, probably due to higher temperatures used during the fabrication process, see Fig. 1. Based on the findings, optimization of heat treatment was suggested and one of the suppliers was recommended.

Anglický abstrakt

This contribution is based on case studies concerning failure of double-wall pipes due to several factors. Series of double wall-pipes from different suppliers were studied using light and electron microscopy in order to reveal defects which led to the failure of each set of the pipes. Pipes, made of combination of steel and copper were analysed in the initial state and after heat treatment. Heat treatment, was performed by the suppliers, not further specified, and varied between suppliers [1, 2]. Metallographic analysis revealed unsuitable microstructure of steel layers and heterogeneity in Cu layer. More detailed analysis revealed precipitation of Cu-based phase on the Cu-steel interface resulting from heat treatment process, but for one set of tubes, precipitates were observed even in the initial state, probably due to higher temperatures used during the fabrication process, see Fig. 1. Based on the findings, optimization of heat treatment was suggested and one of the suppliers was recommended.

Klíčová slova

heat treatment; steel; copper;, light microscopy; electron microscopy

Klíčová slova v angličtině

heat treatment; steel; copper;, light microscopy; electron microscopy

Autoři

KLAKURKOVÁ, L.; JULIŠ, M.; GEJDOŠ, P.; HORYNOVÁ, M.

Rok RIV

2018

Vydáno

01.01.2017

Nakladatel

Trans Tech Publications Ltd.

Místo

Switzerland

ISBN

978-3-0357-1018-2

Kniha

Metallography XVI

ISSN

0255-5476

Periodikum

Materials Science Forum

Stát

Švýcarská konfederace

Strany od

269

Strany do

273

Strany počet

5

URL

http://www.scientificnet/MSF.891.269

BibTex

@inproceedings{BUT133973,
  author="Lenka {Klakurková} and Martin {Juliš} and Pavel {Gejdoš} and Miroslava {Horynová}",
  title="The Use of Microstructural Analysis for the Evaluation of Quality of Double-Wall Pipes",
  booktitle="Metallography XVI",
  year="2017",
  journal="Materials Science Forum",
  number="1",
  pages="269--273",
  publisher="Trans Tech Publications Ltd.",
  address="Switzerland",
  doi="10.4028/www.scientificnet/MSF.891.269",
  isbn="978-3-0357-1018-2",
  issn="0255-5476",
  url="http://www.scientificnet/MSF.891.269"
}