Publication result detail

Analyzing the surface layer after WEDM depending on the parameters of a machine for the 16MnCr5 steel

MOURALOVÁ, K.; MATOUŠEK, R.; KOVÁŘ, J.; MACH, J.; KLAKURKOVÁ, L.; BEDNÁŘ, J.

Original Title

Analyzing the surface layer after WEDM depending on the parameters of a machine for the 16MnCr5 steel

English Title

Analyzing the surface layer after WEDM depending on the parameters of a machine for the 16MnCr5 steel

Type

WoS Article

Original Abstract

The efficient wire electric discharge machining (WEDM) technology is an efficient trade-off between the cutting speed and the resulting surface quality. A typical morphology of a surface machined using WEDM contains a large number of craters caused by the electric sparks generated in the cutting process. The paper analyzes the influence of the cutting speed on the quantitative and qualitative evaluation of the surface craters formed on the surface of a workpiece made of the 16MnCr5 steel. Applying metallography to cross-section microscopic slides, diffusion subsurface damages were studied caused by the cutting. The diffusion processes taking place between the electrode and the material machined were studied using a local point EDX microanalysis applied both to the machined surfaces and to the cross sections. A detailed study was also carried out of the brass electrode to measure its wear rate caused by the cutting process as well as its degradation in terms of the quality of its morphology and the chemical composition of surface.

English abstract

The efficient wire electric discharge machining (WEDM) technology is an efficient trade-off between the cutting speed and the resulting surface quality. A typical morphology of a surface machined using WEDM contains a large number of craters caused by the electric sparks generated in the cutting process. The paper analyzes the influence of the cutting speed on the quantitative and qualitative evaluation of the surface craters formed on the surface of a workpiece made of the 16MnCr5 steel. Applying metallography to cross-section microscopic slides, diffusion subsurface damages were studied caused by the cutting. The diffusion processes taking place between the electrode and the material machined were studied using a local point EDX microanalysis applied both to the machined surfaces and to the cross sections. A detailed study was also carried out of the brass electrode to measure its wear rate caused by the cutting process as well as its degradation in terms of the quality of its morphology and the chemical composition of surface.

Keywords

WEDM, electrical discharge machining, design of experiment, surface investigation, metallography, EDX

Key words in English

WEDM, electrical discharge machining, design of experiment, surface investigation, metallography, EDX

Authors

MOURALOVÁ, K.; MATOUŠEK, R.; KOVÁŘ, J.; MACH, J.; KLAKURKOVÁ, L.; BEDNÁŘ, J.

RIV year

2017

Released

01.12.2016

Location

Spojené státy americké

ISBN

0263-2241

Periodical

MEASUREMENT

Volume

2016

Number

94

State

United Kingdom of Great Britain and Northern Ireland

Pages from

771

Pages to

779

Pages count

9

URL

http://authors.elsevier.com/sd/article/S0263224116305310

BibTex

@article{BUT128110,
  author="Kateřina {Mouralová} and Radomil {Matoušek} and Jiří {Kovář} and Jindřich {Mach} and Lenka {Klakurková} and Josef {Bednář}",
  title="Analyzing the surface layer after WEDM depending on the parameters of a machine for the 16MnCr5 steel",
  journal="MEASUREMENT",
  year="2016",
  volume="2016",
  number="94",
  pages="771--779",
  doi="10.1016/j.measurement.2016.09.028",
  issn="0263-2241",
  url="http://authors.elsevier.com/sd/article/S0263224116305310"
}